Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateFast, Reliable Furnace Repair Across Shady Hollow
Furnace repair in Shady Hollow typically runs $150 – $700, and most calls we handle in the neighborhood are diagnosed and fixed the same day. If your heat cuts out on a cold February morning off Brodie Lane, you don’t want to wait around half the week. Our crew knows Shady Hollow’s houses – the 1980s two-stories with original ductwork, the custom builds with high ceilings and single-zone systems. That local knowledge means we find the real problem faster, not just the obvious one. Call (361) 204-1605 and a live person picks up, 24 hours a day.
Why Cold Harbour Heating and Air Austin Is Shady Hollow’s Preferred Furnace Repair Company
Cold Harbour Heating and Air has been fixing furnaces in Shady Hollow long enough to know which streets have what equipment. The homes off Brodie Lane were largely built in the 1980s and 1990s, and a lot of them still run the original furnaces they came with. Our Furnace Repair team gets called out to Shady Hollow for blower motors that quit, ignitors that stopped glowing, gas valves that won’t open, and heat exchangers that cracked after thirty years of Austin-area cycles.
Victor Mancini, who leads our operation, expects every technician to work by The Kingswell Way: state the price in writing before the work starts, show up in the window we give, leave the site cleaner than we found it, and put the guarantee on paper. Every repair we do in Shady Hollow carries a 365-Day Done Right Promise. If the repair fails within a full year, we come back and make it right at no charge. Not a verbal promise. Written down before the technician leaves your driveway.
Our technicians are background-checked and uniformed, trained on nine major HVAC brands including Carrier, Trane, and American Standard. When they arrive at a home in Shady Hollow, they know the system they’re looking at and the house it’s attached to.
Styles & brands we work with
Gas Furnace Repair in Shady Hollow
Gas Furnace Repair is the most common call we run in Shady Hollow from November through March. Most homes here use natural gas furnaces, and the failure points are consistent: ignitors that stop glowing, flame sensors coated with carbon, gas valves that won’t open, and blower motors that run hot until they quit. A gas furnace repair in Shady Hollow usually falls between $150 and $450 for the common parts, while heat exchanger work or blower motor replacement can push the total toward $700.
Ignitor and Flame Sensor Work
A furnace that clicks but won’t light is usually the ignitor. It’s a small ceramic part that glows hot enough to light the gas. When it cracks, the furnace just sits there. In Shady Hollow, we replace ignitors on furnaces from the original 1980s and 1990s installs regularly. Most ignitor replacements run $150 – $280, parts and labor included.
Gas Valve and Safety Control Repair
If the ignitor works but the gas valve doesn’t open, the burner never lights. Gas valves fail due to age, sticky solenoids, or a fried control board. This is not a part to guess at. We test the valve under load before replacing anything, and we quote the exact price before we touch a tool. If the furnace is misfiring or shutting down intermittently, call us before the cold snap hits: that intermittent fault rarely fixes itself.
Furnace Tune Up in Shady Hollow
A Furnace Tune Up is the cheapest insurance a Shady Hollow homeowner can buy for their heating system, and it costs $80 – $200. Given the Edwards Aquifer recharge zone underneath much of the neighborhood, a tune-up is also the time to check that the furnace condensate is being handled correctly. We inspect the burners, test the flame sensor, check the gas pressure, inspect the heat exchanger for cracks, measure the temperature rise, and verify that the condensate line is draining properly.
Heat Exchanger Inspection
A cracked heat exchanger can put carbon monoxide into your home. It’s the single most important check in a tune-up, and it cannot be done with a glance. Shady Hollow homes with original 1980s and 1990s furnaces are exactly the demographic where we find hairline cracks starting. We inspect with a borescope and a combustion analyzer, not just a flashlight and a hunch. If we find a crack, we show you the photo and explain your options. If the furnace is safe, we tell you that too, in writing.
Condensate and Drainage Check
High-efficiency furnaces produce acidic condensate that should never just dump onto the ground in Shady Hollow. Because much of the neighborhood sits over the Edwards Aquifer recharge zone, discharge and handling requirements are stricter than what a homeowner in a flat, non-recharge part of Travis County would face. During every tune-up, we check the condensate trap, clean the line, and confirm the discharge point complies with local environmental rules. If it doesn’t, we’ll tell you exactly what needs to change and what it costs.
Trusted Brands We Service in Shady Hollow
Our technicians are factory-familiar with Daikin, Bryant, and American Standard, along with six other major residential brands. That means the person who shows up at your door in Shady Hollow has worked on your brand’s equipment before, not just read about it in a manual. We keep common parts stocked on the truck – ignitors, flame sensors, capacitors, pressure switches – so most repairs happen in a single visit. If your furnace is a twenty-year-old Bryant or a newer Daikin, the repair path looks different, and we’ll walk you through it honestly before any money changes hands.
See the difference
Before
After
Before
After
Before
AfterCommon Furnace Repair Problems We See in Shady Hollow Homes
- High static pressure killing blower motors. Original 1980s and 1990s ductwork in Shady Hollow was often undersized at install. When the furnace pushes against those tight, leaky ducts, the blower motor overheats and fails years early. We see this constantly on the custom homes off Brodie Lane and Mowry Drive.
- Single-zone systems with hot and cold spots. Most Shady Hollow homes from this era have one thermostat for a two-story, open floor plan. Heat rises, so upstairs rooms bake while downstairs stays chilly. The furnace itself may be fine – the problem is balance and duct leakage.
- Aging electrical panels that can’t support a modern furnace swap. A like-for-like replacement sometimes requires more amperage than the original 1980s panel can handle. We always check panel capacity before recommending a new furnace. If a panel upgrade is needed, we’ll tell you before the work is quoted, not after the old unit is out.
- Condensate handling on Edwards Aquifer recharge zone properties. High-efficiency furnaces create acidic water as a byproduct. In Shady Hollow, that discharge needs to be routed and reported correctly. It’s an environmental compliance issue that a tech from Sunset Valley or Manchaca would rarely think to flag.
Pricing for Furnace Repair in Shady Hollow, TX
Here’s what furnace repair actually costs in Shady Hollow. We quote these numbers up front, in writing, before the work begins.
| Service | Typical Price Range |
|---|---|
| Furnace Repair | $150 – $700 |
| Furnace Tune Up | $80 – $200 |
Where your repair lands in that range depends on the part and the system. An ignitor replacement is usually $150 – $280. A blower motor runs $300 – $500. A heat exchanger repair or replacement lands at the top of the range, and sometimes it’s the moment to talk about whether a twenty-five-year-old furnace is worth pouring more money into. We’ll show you the numbers and let you decide. Estimates are free, and the price we write down is the price you pay. Call (361) 204-1605.
We Also Serve Cities Near Shady Hollow
While this page is about Shady Hollow, our crews also handle furnace repair for homeowners in Austin, Round Rock, Pflugerville, and Leander. If you’re across the city line and your heat failed, the same pricing and the same written guarantee apply. We dispatch technicians who know the Travis County and Williamson County terrain, so a call from Round Rock gets the same fast response as one from Brodie Lane in Shady Hollow.
Serving Shady Hollow, TX - Our Local Coverage Area
We’re based in the Shady Hollow area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Furnace Repair in Shady Hollow
The most likely cause is duct leakage and an oversized or unbalanced system. In Shady Hollow’s custom homes from the 1980s and 1990s, original ductwork in unconditioned attics leaks significantly, which throws off the thermostat’s temperature readings and causes the system to cycle on and off too often. The fix isn’t another new motor – it’s sealing the ducts and, if needed, recalibrating the thermostat to work with the corrected airflow. Call (361) 204-1605 and we’ll test your static pressure and duct leakage before recommending anything.
No, you don’t need to file a report yourself before a repair, but the condensate discharge does need to comply with Edwards Aquifer recharge zone rules, and that’s something we handle for you. We will inspect where your furnace condensate currently drains, correct it if it’s discharging improperly, and document what was done. That documentation protects you if a code or compliance question ever comes up during a home sale or inspection.
You can, but in Shady Hollow homes of that era, a like-for-like swap often disappoints. The original ductwork was frequently undersized and is almost certainly leaking after thirty years in an unconditioned attic. If you put a new furnace on old, leaky ducts, the blower motor will run against high static pressure and fail early – exactly the problem we see on homes off Brodie Lane. We’ll tell you if a duct sealing or a panel upgrade needs to happen before the new furnace goes in, and we’ll price it all out before any work starts.
Single-zone systems with one thermostat can’t respond to the temperature difference between floors in a two-story home. Heat rises, so the downstairs thermostat gets satisfied while the upstairs rooms stay cold. The fix is usually one of three things: sealing the ducts to improve balance, adding a zoning damper system, or replacing the current setup with a properly sized multi-zone system. We can test your current system and show you the numbers for each option.
Once a year, in the fall, before the first serious cold snap. Homes over the Edwards Aquifer recharge zone should pay special attention to condensate drainage and burner efficiency, both of which are covered in our $80 – $200 tune-up. It’s the cheapest way to catch a cracked heat exchanger early and avoid a mid-winter emergency call. Call (361) 204-1605 to schedule your tune-up, and we’ll put the inspection findings in writing.
Written by Victor Mancini, Owner at Cold Harbour Heating and Air Austin, serving Shady Hollow and the surrounding areas.